CERTIFICATE

IMPACT FACTOR 2021

Subject Area

  • Life Sciences / Biology
  • Architecture / Building Management
  • Asian Studies
  • Business & Management
  • Chemistry
  • Computer Science
  • Economics & Finance
  • Engineering / Acoustics
  • Environmental Science
  • Agricultural Sciences
  • Pharmaceutical Sciences
  • General Sciences
  • Materials Science
  • Mathematics
  • Medicine
  • Nanotechnology & Nanoscience
  • Nonlinear Science
  • Chaos & Dynamical Systems
  • Physics
  • Social Sciences & Humanities

Why Us? >>

  • Open Access
  • Peer Reviewed
  • Rapid Publication
  • Life time hosting
  • Free promotion service
  • Free indexing service
  • More citations
  • Search engine friendly

Sugarcane improvement through mutation and molecular technique

Author: 
Shafquat Yasmeen, Muhammad Tahir Rajput, Imtiaz Ahmed Khan and Syeda Saleha Hasseny
Subject Area: 
Life Sciences
Abstract: 

Mutation breeding has been generally used for the improvement of plant characters in several crops. It is a powerful and effective tool in the hands of plant breeders. In mutation breeding program, selection of an effective and efficient mutagen is very essential to produce high frequency of desirable traits. The three sugarcane clones viz; NIA-0819, NIA-98 and BL4 were selected and subjected with Ethyl methanesulfonate (EMS) doses of 5, 10, and 15 mM and untreated of each variety were used as control. The results indicated for agronomic traits showed that maximum plant height was observed (331.67 cm) in BL4 under control and minimum plant height was observed (209 cm) at 15mM in BL4. The maximum number of tillers plant-1 (7.00) at 10 Mm. The higher number of internodes was noted (16.66) at 10 mM in BL4, maximum number of internodes length (17.31 cm) at 10 mM in NIA-98 and minimum (11.91 cm) at 5 mM in BL4. The results of quality traits indicated that maximum brix (20.33 %) was obtained at 15mM in BL4 and lowest (14.66 %) in 5mM in NIA-0819. The more purity was observed (72.43) at 10 mM in BL4, fibre (15.33) at 5 mM in BL4. The maximum sucrose (14.16 %) was recorded under at 15 mM in BL4, sugar yield (6.14 t ha-1) under control in BL4 and cane yield BL4 was noted (331 t ha-1) at 10 mM in BL4. The selected sugarcane mutants were analyzed by using simple sequence markers (SSR). Out of 13 SSR primers studied, 7 primers were found to be polymorphic, whereas 6 primers were counted to be monomorphic. A total of 495 conformers were analyzed by using 13 SSR primers as presented and 495 bands, 191 bands were polymorphic, showing 38.58 % polymorphism. The maximum number of locus (20) was produced by the primer SMC-703BS and minimum number of bands (8) was produced with primer EST-SSR29. The amplification products in 10 mM (EMS) produced multiple loci, in which the total numbers of 129 scroable bands, out of which 100 were monomorphic. They showed SMC 703BS bands15 was produced with lowest number of bands (8) was obtained with primer EST -SSR 29. The primer no amplification products found in EST-SSR30-5, EST-SSR38. The amplification products in 15 mM (EMS) produced multiple fragments in which the total number of 30 scroable bands was polymorphic. Some specific bands were also identified thus reflecting the SSR application for the identification of sugarcane mutants. The results showed that 15 mM (EMS) indicated 6 primers produced a single polymorphic band and 7 primers produced two polymorphic bands. The genetic similarity indices calculated by Jaccard’s similarity coefficient varied from (0.98 to 0.85 % indicate a high level of genetic similarity among the mutants that was mainly attributed to intra specific diversity. Hence, this SSR technique helped to identify the genetic variation in mutant plants.

PDF file: 

CALL FOR PAPERS

 

ONLINE PAYPAL PAYMENT

IJMCE RECOMMENDATION

Advantages of IJCR

  • Rapid Publishing
  • Professional publishing practices
  • Indexing in leading database
  • High level of citation
  • High Qualitiy reader base
  • High level author suport

Plagiarism Detection

IJCR is following an instant policy on rejection those received papers with plagiarism rate of more than 20%. So, All of authors and contributors must check their papers before submission to making assurance of following our anti-plagiarism policies.

 

EDITORIAL BOARD

Dr. Swamy KRM
India
Dr. Abdul Hannan A.M.S
Saudi Arabia.
Luai Farhan Zghair
Iraq
Hasan Ali Abed Al-Zu’bi
Jordanian
Fredrick OJIJA
Tanzanian
Firuza M. Tursunkhodjaeva
Uzbekistan
Faraz Ahmed Farooqi
Saudi Arabia
Eric Randy Reyes Politud
Philippines
Elsadig Gasoom FadelAlla Elbashir
Sudan
Eapen, Asha Sarah
United State
Dr.Arun Kumar A
India
Dr. Zafar Iqbal
Pakistan
Dr. SHAHERA S.PATEL
India
Dr. Ruchika Khanna
India
Dr. Recep TAS
Turkey
Dr. Rasha Ali Eldeeb
Egypt
Dr. Pralhad Kanhaiyalal Rahangdale
India
DR. PATRICK D. CERNA
Philippines
Dr. Nicolas Padilla- Raygoza
Mexico
Dr. Mustafa Y. G. Younis
Libiya
Dr. Muhammad shoaib Ahmedani
Saudi Arabia
DR. MUHAMMAD ISMAIL MOHMAND
United State
DR. MAHESH SHIVAJI CHAVAN
India
DR. M. ARUNA
India
Dr. Lim Gee Nee
Malaysia
Dr. Jatinder Pal Singh Chawla
India
DR. IRAM BOKHARI
Pakistan
Dr. FARHAT NAZ RAHMAN
Pakistan
Dr. Devendra kumar Gupta
India
Dr. ASHWANI KUMAR DUBEY
India
Dr. Ali Seidi
Iran
Dr. Achmad Choerudin
Indonesia
Dr Ashok Kumar Verma
India
Thi Mong Diep NGUYEN
France
Dr. Muhammad Akram
Pakistan
Dr. Imran Azad
Oman
Dr. Meenakshi Malik
India
Aseel Hadi Hamzah
Iraq
Anam Bhatti
Malaysia
Md. Amir Hossain
Bangladesh
Ahmet İPEKÇİ
Turkey
Mirzadi Gohari
Iran