CERTIFICATE

IMPACT FACTOR 2021

Subject Area

  • Life Sciences / Biology
  • Architecture / Building Management
  • Asian Studies
  • Business & Management
  • Chemistry
  • Computer Science
  • Economics & Finance
  • Engineering / Acoustics
  • Environmental Science
  • Agricultural Sciences
  • Pharmaceutical Sciences
  • General Sciences
  • Materials Science
  • Mathematics
  • Medicine
  • Nanotechnology & Nanoscience
  • Nonlinear Science
  • Chaos & Dynamical Systems
  • Physics
  • Social Sciences & Humanities

Why Us? >>

  • Open Access
  • Peer Reviewed
  • Rapid Publication
  • Life time hosting
  • Free promotion service
  • Free indexing service
  • More citations
  • Search engine friendly

Numerical analysis of The Tube Bank pressure drop of a Shell and tube heat exchanger using flat face header

Author: 
Kartik Ajugia, Aksheshkumar A. Shah, Rohit A. Rawool, Siddharth S. Saini and Tejas P. Shah
Subject Area: 
Physical Sciences and Engineering
Abstract: 

Pressure drop is the main parameters describing the efficiency and acceptance of a particular shell and tube heat exchanger in any application. Pressure drop across the tube side is inversely proportional to the viz. Higher the pressure drop lower is the heat transfer and hence the required pumping power is high and correspondingly higher is the expense. The pressure drop on the tube side can be trichotomized as pressure drop due to Inlet nozzle, pressure drop in the tube bank, and pressure drop in the outlet nozzle. This report provides an insight into the research done on the analysis of the pressure drop in the tubes of a shell and tube heat exchanger. Although a remarkable contribution has been done through analytical relations governing the pressure drop and the numerical analysis of the pressure drop on the shell side of a shell and tube heat exchanger, cogent contribution can be made numerically on the tube side. The approach provided enables us to study detailed flow behavior (pressure drop) in the tubes using the TEMA BEM viz. a Flat Head Single Pass SHTX numerically viz. the use of computation for the mentioned research. Hence to achieve the task numerically the use of ANSYS16.0has been made assuming that the flow is steady and isothermal. Two different pressure zones have been identified viz. (1) High pressure drop zone (2) Low pressure drop zone across the tube banks. It was observed that nearly fifty percent of the tubes lie under each category. The pressure drop has been computed numerically at a specific inlet velocity and then correlated at different inlet velocities for a parametric study.

PDF file: 

CALL FOR PAPERS

 

ONLINE PAYPAL PAYMENT

IJMCE RECOMMENDATION

Advantages of IJCR

  • Rapid Publishing
  • Professional publishing practices
  • Indexing in leading database
  • High level of citation
  • High Qualitiy reader base
  • High level author suport

Plagiarism Detection

IJCR is following an instant policy on rejection those received papers with plagiarism rate of more than 20%. So, All of authors and contributors must check their papers before submission to making assurance of following our anti-plagiarism policies.

 

EDITORIAL BOARD

Dr. Swamy KRM
India
Dr. Abdul Hannan A.M.S
Saudi Arabia.
Luai Farhan Zghair
Iraq
Hasan Ali Abed Al-Zu’bi
Jordanian
Fredrick OJIJA
Tanzanian
Firuza M. Tursunkhodjaeva
Uzbekistan
Faraz Ahmed Farooqi
Saudi Arabia
Eric Randy Reyes Politud
Philippines
Elsadig Gasoom FadelAlla Elbashir
Sudan
Eapen, Asha Sarah
United State
Dr.Arun Kumar A
India
Dr. Zafar Iqbal
Pakistan
Dr. SHAHERA S.PATEL
India
Dr. Ruchika Khanna
India
Dr. Recep TAS
Turkey
Dr. Rasha Ali Eldeeb
Egypt
Dr. Pralhad Kanhaiyalal Rahangdale
India
DR. PATRICK D. CERNA
Philippines
Dr. Nicolas Padilla- Raygoza
Mexico
Dr. Mustafa Y. G. Younis
Libiya
Dr. Muhammad shoaib Ahmedani
Saudi Arabia
DR. MUHAMMAD ISMAIL MOHMAND
United State
DR. MAHESH SHIVAJI CHAVAN
India
DR. M. ARUNA
India
Dr. Lim Gee Nee
Malaysia
Dr. Jatinder Pal Singh Chawla
India
DR. IRAM BOKHARI
Pakistan
Dr. FARHAT NAZ RAHMAN
Pakistan
Dr. Devendra kumar Gupta
India
Dr. ASHWANI KUMAR DUBEY
India
Dr. Ali Seidi
Iran
Dr. Achmad Choerudin
Indonesia
Dr Ashok Kumar Verma
India
Thi Mong Diep NGUYEN
France
Dr. Muhammad Akram
Pakistan
Dr. Imran Azad
Oman
Dr. Meenakshi Malik
India
Aseel Hadi Hamzah
Iraq
Anam Bhatti
Malaysia
Md. Amir Hossain
Bangladesh
Ahmet İPEKÇİ
Turkey
Mirzadi Gohari
Iran